Smeg WCP32SB - Manual (Page 4)

Instructions for Use 38
Installation
Selection of Room
Place the appliance in a dry well-aired room.
Allowed ambient temperature depends on the
model (class) of the appliance and ist stated on
the rating plate of the appliance.
Do not place the appliance in wet cellar, on
balcony, near cooker, radiator, water heater and
similar and do not expose it to direct sunlight.
The appliance should be placed in horizontal
position on a firm base which remains stable
even after you have fully loaded the freezer.
Class Ambient temperature
SN (sub-normal) from +10°C to 32°C
N (normal) from +16°C to 32°C
ST (sub-tropical) from +18°C to 38°C
T (tropical) from +18°C to 43°C
Cooling of the Appliance
The appliance is not intended to be built-in the
kitchen cabinet.
Provide for enough space on either side of the
appliance (2-3 cm) for unobstructed air
circulation.
Cooling of the rear of the appliance is of special
importance.
x Freezers having the switches in the front, can
be pushed up to the wall as the hinges of the lid
define the minimum required distance
between the wall and the appliance.
x Freezers having the switches in the lid are
equipped with two spacers. Insert them into the
holes on the rear side in order to determine the
right distance of the appliance from the wall.
Connection to the Mains Supply
Connect the appliance with the cable and plug to
the mains supply socket with a ground terminal
(safety socket).
Required nominal voltage and frequency are
indicated in the rating plate.
The connection to the mains supply and earthing
of the appliance have to be made according to
valid standards and regulations.
The appliance resists temporary voltage fluc-
tuations but only in the tolerance of -15 to +10%.