Samsung SCX-5115 - Manual (Page 132)

I NSTALLING A N ETWORK O PTION A.9
A
10 Enter a number between 0 and 255 for each byte and press
Mode/Enter (Enter for SCX-5115).
You can move between each byte by pressing or .
11 Repeat steps 6 through 8 to configure the other TCP/IP
parameters, such as subnet mask and gateway.
12 When you are finished, press Stop/Clear.
Dynamic Addressing (BOOTP/DHCP)
To allow the server to automatically assign the TCP/IP address,
take the following steps:
1 Press Menu/Exit and then System Setup on the one-
touch dial keypad. SCX-5115 users should press Menu and
then Enter.
2 Press or to display “NETWORK SETUP” on the top line.
3 Press or to display “CONFIG NETWORK” on the
bottom line.
4 Press Mode/Enter (Enter for SCX-5115) to access the
menu.
The first option, “CONFIGURE TCP” displays on the bottom
line.
5 Press Mode/Enter (Enter for SCX-5115) to access the
menu.
6 Press or to select the server to assign the TCP/IP
address, DHCP or BOOTP.
7 Press Mode/Enter (Enter for SCX-5115) to save the
selection.
8 When you are finished, press Stop/Clear.