Sharp AR-C265P - Manual (Page 107)

Sharp AR-C265P User’s Guide
107
Network Menu
Note: Factory default settings are shown in bold.
Item Settings Explanation
TCP/IP ENABLE
DISABLE Enables or disables this network
protocol.
NETBEUI ENABLE
DISABLE Enables or disables this network
protocol.
IP ADDRESS
SET AUTO
MANUAL Change this to Manual to specify the IP
address through the front panel (see
next entry). Required for non-DHCP
networks.
IP ADDRESS xxx.xxx.xxx.xxx
Default =
198.168.100.100 Current assigned IP address. To
change:
• Press ENTER.
• Use
+ / – keys to increment first
octet.
• Press ENTER to move on to the next
octet.
• Use + / – keys to increment second
octet.
• Press ENTER to move on to the next
octet.
• Use + / – keys to increment third
octet.
• Press ENTER to move on to the last
octet.
• Use + / – keys to increment 1st
octet.
• Press ENTER to register the new
address.
SUBNET MASK xxx.xxx.xxx.xxx
Default =
255.255.255.000 Current assigned subnet mask. To
change, proceed as above.
GATEWAY
ADDRESS xxx.xxx.xxx.xxx
Default =
192.168.100.254 Current assigned gateway address. To
change, proceed as above.
Factory Default [EXECUTE] Initializes the network card.
WEB/IPP ENABLE
DISABLE Enables or disables Web config. facility
and Internet Printing Protocol.
This item will not appear in the menu if
TCP/IP is set to DISABLE.