Sanyo 710-00792-1 - Manual (Page 5)

4
SETUP PROJECTION MIRROR
Remove the 4 Protection Pads inside of the Top
Cabinet and remove the 2 Fixing Bands (right and
left) of the Projection Mirror.
Remove the 8 Screws(A) of the Mirror Arms. Lift
the Projection Mirror and raise the Mirror Arms
backward.
Loosen the Screws(B) on the end of the Mirror
Arms. Put the Mirror Holder between the Adjusting
Nut and the Washer at each side of the Mirror. And
then fix the Mirror Holders on the Mirror Arms with
the Screws(B) temporary.
Fix the Mirror Arms on the Cabinet with the
Screws(A). Fix the Projection Mirror to the end of
the Mirror Arms with the Screws(B) securely.
Preparation
Set Mirror Arms
Fix Projection Mirror
1
2
3
CAUTION
NEVER TOUCH THE PROJECTION
MIRROR DIRECTLY. IT MAY EFFECT THE
PROJECTION IMAGE QUALITY. MOVE
THE MIRROR BY HOLDING THE MIRROR
HANDLE.
BE SURE TO REMOVE ALL THE
PROTECTION PADS FROM THE CABINET.
Projection Mirror
Fixing Bands
Projection Mirror
Fixing
Bands
(2 pcs)
Screws(A)
(4 pcs X 2) Mirror Arm
Mirror Handle
Screws(A)
(4 pcs X 2)
Mirror Arm
Screw(B)
Protection Pads (4pcs)
Adjusting Nut Screw(B)
Washer
Mirror Arm
Mirror Holder