Smeg CV10B - Manual (Page 14)

Instructions for Use 72
Changing the Direction of Opening the Door
If you find the direction of opening the door on your appliance
inconvenient, you can change it. Holes on the opposite side have
already been prepared in the factory and are now plugged.
• Unscrew the lower hinge with foot and remove the door ot the
appliance.
• Unscrew the other foot and fix it on the place where previously was
the hinge with the foot.
• Rotate the fastener having the function of the upper hinge counter
clockwise, take it off and replace it on the opposite side of the door.
• Take off all door corners and interchange them (instead of the corner
with a hole insert the one without the hole and vice versa).
• Put the door on the fastener having the function of the upper hinge.
• Put the fastener with foot of the lower hinge (with a washer) into the
plastic corner with a hole and fix the lower hinge.
• Unscrew the handle and replace it on the opposite side (not for
handles mouinted horizontally).
Some screws are covered with caps. Take them off before undoing
the screws.
• Plug the remaining holes with decorative caps.
• Check the gasket, it shouldn't be creased and it should seal well.