Sharp LL-T2020 - Manual (Page 11)

11
English
Deutsc
h
Fran
ç
ais
Italiano
Espa
ñ
ol
English
Connecting the monitor and turning the monitor on and off
CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to overly bend the cable or add
extension cords as this could lead to a
malfunction.
Cable storage
If necessary, excess cable can be housed in the
stand.
1.Remove the cover.
Gently pull the top of the cover towards yourself.
2.Run cable along the back of the stand.
Pass cable in front of the stand, and then bring it
through the back.
- If the display is to be rotated, first house the
cables with the display in the long height
position, so there is sufficient length when the
display is turned.
3.Refit the cover.
Be careful not to pinch the cable.
- If the cover is hard to refit, do not force it.
Check whether cables are trapped.
CAUTION!
- If the display is to be rotated, first house the
cable, and then check while gently turning the
display. If it cannot be turned, rehouse the cable
with sufficient slack. (If there is insufficient cable
length, rotation will be impossible. Forcing
rotation may cause cable disconnection.)
Connecting the monitor to a computer
The accessory signal cable enables connection of
two computers.
(One analog and one digital connection.)
- To achieve an analog and digital connection for
two computers, a separately sold signal cable is
required.
- The separately sold 2-input cable enables
connection of two computers to the DVI-I input
terminal.
- When using the 2-input cable, set the connecting
input terminal [INPUT-1] or [INPUT-2] to [2LINES]
under the MODE SELECT-1 Menu. (p.20, 23)