SUUNTO t3d - Manual (Page 31)

5 USING SPEED AND DISTANCE MODE
The SPEED AND DISTANCE mode becomes available after you have paired a speed and
distance POD with your Suunto heart rate monitor.
5.1 Pairing a POD
To use SPEED AND DISTANCE mode, you first need to pair your Suunto heart rate monitor
with a Suunto POD.
To pair a POD:
1. In TRAINING mode, enter the menu ( SET ) and scroll with [Lap +] until you reach
PAIR A POD .
2. Press [Mode] to get to the first setting and select the POD type using [Lap +] and
[Light -].
3. Press [Mode] to activate pairing.
4. Turn on the POD while message
TURN ON is displayed.
Use the same procedure to pair you heart rate transmitter belt.
NOTE: Before you (re)pair your POD or belt, you need to first reset the device by removing
the battery and putting it in backwards (positive side down). Then replace the battery
normally.
30