Southbend SB1022 - Manual (Page 12)

-10-
For Machines Mfg. Since 8/09 Model SB1021/SB1022 S A F E T Y
Additional Metal Cutting Bandsaw Safety
7. Magnesium Fire Hazard: Use EXTREME
CAUTION if cutting magnesium. Using
the wrong cutting fluid or overheating the
material could lead to an extremely hot fire
that is difficult to extinguish. Additionally,
do not allow magnesium swarf or dust to pile
up around the machine and only dispose of
the waste using approved methods.
8. Entanglement Hazards: Always keep the
blade guard correctly positioned and wheel
doors closed and secured when bandsaw is in
operation. Loose clothing, jewelry, long hair
and work gloves can be drawn into working
parts.
9. Maintenance/Service: All inspections,
adjustments, and maintenance are to be
done with the power OFF and the plug
pulled from the outlet. Wait for all moving
parts to come to a complete stop.
10. Unstable Workpieces: Workpieces that
cannot be supported or stabilized without
a vise or jig should not be cut on a vertical
metal-cutting bandsaw, because they can
unexpectedly move while cutting and
draw the operator's hands into the blade
causing serious personal injury. Examples
are chains, cables, round or oblong-shaped
workpieces, workpieces with internal or
built-in moving or rotations parts, etc.
11. Clearing Chips: Metal chips can easily cut
skin—even through a piece of cloth. Avoid
clearing chips by hand or with a rag. Use a
brush or vacuum to clear metal chips.
1. Blade Condition: Do not operate with a
dull, cracked or badly worn blade—they can
break during use or greatly decrease cutting
performance. Inspect blades for cracks and
missing teeth before each use.
2. Blade Replacement: Wear gloves to protect
hands and safety glasses to protect eyes
when replacing the blade. When replacing
blades, make sure teeth face forward and
down toward the table in the direction of
blade travel.
3. Workpiece Handling: Your hands can be cut
or drawn into the blade during operation if
the workpiece moves unexpectedly. Always
keep your hands a safe distance away from
the moving blade.
4. Welding And Grinding Safety: The welding
station can be hazardous if used incorrectly
and without proper personal protection.
Always wear welding-approved gloves,
eye protection, and clothing when welding
blades. Touching any metal parts of the
blade, welder, or machine when activating
the welder could lead to electrocution.
Welding near flammables could cause a fire.
5. Hot Surfaces: Be aware that touching hot
workpieces or chips after welding, grinding,
or cutting can cause burns.
6. Cutting Fluid Safety: This machine is
designed for dry cutting operations. Flood-
type cutting fluid setups should not be used
because the machine is not waterproof.