Setting up tour appliance – Smeg VR105NE1 User Manual

Page 12

Advertising
background image

10

GB

a

A

B

c d b

a

d

b

c

Fig. 1

Control Panel

Recessed freezers have 2 different types of control panel as
shown in figure 1; corresponding with the one on the
appliance your have purchased.

Thermostat ’’a’’

This regulates the temperature inside the appliance
automatically. Turn the knob from setting 1 to 3 for
increasingly colder temperatures.To adjust the thermostat,
use a coin to turn the knob.

Green Light ’’b’’

Type “A” control panel.
When the light is on (move the switch to the right) this
indicates that the appliance is connected to the mains.
When the switch is moved to the left (green light covered),
the appliance is disconnected from the mains.
Type “B” control panel.
When lit it shows the appliance is connected to the mains.

Yellow Light ’’c’’

Type “A” control panel.
When this light is on (move the switch to the left), the
compressor will operate continuously to reach the lower
temperatures necessary for freezing fresh foods quickly.
By moving the switch to the right (yellow light covered) the
freezer is operated by the thermostat.
Type “B” control panel.
When lit (on setting “S”) the compressor runs continuously
to reach the low temperatures necessary for freezing fresh
foods. When off, the freezer is operated by the thermostat.

Red Light ’’d’’

This light goes on when the temperature inside the appliance
is not sufficient to preserve foodstuffs.

Setting up tour appliance

ATTENTION
After transport stand the appliance upright and wait
at least 3 hours before plugging the appliance into the
mains to ensure proper performance.
Use these average temperature settings to ensure op-
timum performance and save energy.

Once the appliance has been connected to the mains, ensure
that the green light is on and turn the yellow light on as
well.
When the red light is off, turn off the yellow light: the
appliance is now ready for use.

Advertising