Silvercrest SWKG 3000 A1 - Manual (Page 6)

- 4 -
ƽ
Warning
Remove the power plug from the wall socket before
you take the kettle from the base
y . This prevents
causing a potential short circuit by water possibly
spilling out of the carafe and falling onto live electrical
connections in the base
y .
ƽ
Injury hazard
For safety reasons, the lid w should not be opened
while the water is boiling or is very hot. There is a
risk of receiving severe scalds.
Cleaning and Care
ƽ
Danger
Do not open any part of the housing. There are no
user-servicable elements inside. An open housing
can create the risk of a lethal electrical shock.
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered com-
ponents.
Before cleaning the appliance, ....
• first, remove the plug from the power socket and
allow the appliance to cool down completely.
• Clean the exterior surfaces and the power cable u
with a slightly damp cloth. Be sure to dry the
appliance well before taking it back into use.
• Never use detergents, abrasive cleaners or
solvents. These can damage the appliance.
In the event of scale deposits:
• Before descaling, remove the pourer sieve (see
chapter "Removing/replacing the pouring sieve").
• Obtain any decalcifying agent suitable for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a hardware shop. Proceed as detailed in the
instructions provided for the use of the decalcfying
agent.
• For cleaning the stainless steel container bottom
you can use a suitable product from a specialist
dealer .
Removing the lid
To make the cleaning of the appliance interior easier,
you can remove the lid
w :
• Open the lid w .
• Press the lid w , as shown in the diagramme, to
the rear q .
• You can then pull out the hinge and lift out the
lid w , as shown in the diagramme w .
• On reassembly, ensure that the lid w is put in
the correct way round. The thickening at the frame
of the lid
w must point upwards when it is being
replaced, and also the level surface of the frame
to the handle
r . Otherwise, the lid w cannot
be closed!
w
q
IB_54368_SWKG3000A1_LB6 15.07.2010 17:05 Uhr Seite 4