Samsung SIR-TS360 - Manual (Page 29)

29
CHAPTER 3
Setting up and connecting
3 3
RF REMOTE jack and cable
RF REMOTE jack and cable are used to operate the
Digital Satellite Receiver when installed in a cabinet or
from another room in your house using the RF remote
control.
Use this jack and cable to connect the RF Receiver to the
RF REMOTE jack of the Digital Satellite Receiver.
DVI jack and cable (cable not included)
Using the DVI jack and a digital DVI cable, your DIRECTV ® HD
Receiver can provide the unconverted digital signal from digital
off-air, cable, or DIRECTV
® programming directly to A/V devices
that are capable of decoding the digital video information.
The DVI jack uses HDCP content protection to allow you to view
HD programming that has been encoded using the HDCP
protection system.
For the best access to HD programming at the highest available
resolution, connect this to a HDTV that supports HDCP technology.
(This cable carries video only; use with audio cables for the audio
signal.)
RGB OUT jack and cable (cable not included)
RGB OUT jack and cable use a computer-standard 15-pin VGA
video connection.
Each main video color, Red, Green, and Blue uses a separate
pin; and other pins are used to carry vertical and horizontal
sync signals.
Using the RGB OUT jack and an RGB cable, you can connect
your DIRECTV
® HD Receiver to devices equipped with RGB input
jacks (computer monitors, for example).
The RGB Out jack can carry any of the Digital TV and HDTV
video resolutions. (This cable carries video only; use with audio
cables for the audio signal.)
SIR-TS360-CHAPTER 3 11/18/03 9:42 AM Page 29