Messages and signals – Sharp UX-305 User Manual

Page 113

Advertising
background image

UX305U-TSDM

RT

<P=001>

Messages and Signals

Display messages

Note: If you have turned on the Caller ID function, see Caller ID in
Chapter 7 for display messages related to Caller ID.

CHECK PAPER SIZE

The paper size setting is incorrect. Change the paper
size setting as described in

Loading the Paper in

Chapter 1.

COVER OPEN

The print compartment cover (under the operation
panel) is open. Open the operation panel (grasp the
top and pull toward you), and then press down firmly
on both sides of the print compartment cover to close
it.

DOCUMENT JAM

The original document is jammed. See the following
section,

Clearing Paper Jams.

FAX RX IN MEMORY

A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.

FILM END

The imaging film may need replacement. Check the
film and replace if necessary.

FUNCTION MODE

The FUNCTION key has been pressed.

HOLD

The HOLD/SEARCH key has been pressed to put
the other party on hold during a phone conversation.
Press the HOLD/SEARCH again to take the other
party off hold.

LINE ERROR

Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see

Line Error in Problems and

Solutions in this chapter.

LINE IS IN USE

An extension phone connected to the fax is being
used. Do not lift the fax’s handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.

11.

Tr

oub

le

-

s

hoot

in

g

Display Messages

111

Advertising