Sunbeam MR. COFFEE SPR-062609 - Manual (Page 4)

To Set the Delay Brew Time:
After setting the clock, simply press and hold the SET DELAY button
(Figure 1), and set the brew time by pressing the HOUR and MINUTE
buttons. The PM indicator will display when a PM hour is shown.
NOTE: To activate the DELAY BREW cycle, see the “Brewing
Coffee Later” section.
To check the programmed time, push the SET DELAY button. The
display will show the time you have programmed the coffee to brew.
P R E PA R I N G F O R U S E
Selecting and Measuring Ground Coffee
For best results, use a level tablespoon for ground coffee measurement.
Make sure you use medium grind coffee for a perfect brew.
Suggested Coffee Measurement Chart
To Brew Ground Coffee
5 Cups 6 tbsp.
2 Cups 3 tbsp.
Adding Water and Ground Coffee
1. Lift and open the coffeemaker lid. For your convenience, you can
lift out the removable filter basket.
2. Place a MR. COFFEE ® brand 4 cup paper basket-style filter or a
MR. COFFEE ® permanent filter into the removable filter basket.
(Figure 2)
NOTE: If using paper filters, it is important that the sides of the
filter fit flush against the side of the filter basket. If filter collapse
occurs, dampen the filter before placing in the filter basket and
adding ground coffee and water.
3. Add the desired amount of coffee and gently shake to level the
coffee. See the Suggested Coffee Measurement Chart.
4. Be sure the filter basket is properly centered and all the way
down in the filter basket.
5. Fill the decanter with cold, fresh water to the desired capacity (1 cup equals 5 ounces). For
easy and accurate filling, the water markings on the glass decanter and on the dual water
windows show the amount of water needed to make the corresponding desired number of
cups. Do not fill past the “MAX line” or water will flow out of the overfill hole in the back of
the water reservoir.
The amount of coffee brewed will always be slightly less than the amount of
water poured in the water reservoir. This is due to the minimum absorption
of water by the coffee grounds.
6. Pour the water into the water reservoir. Close the lid and place the empty decanter onto the
warming plate.
NOTE: Make sure the decanter is fully placed on the warming plate or the water
and the grounds will overflow from the filter basket. An overflow may cause personal
injury or damage to property.
CAUTION! To reduce the risk of damaging the decanter and/or the risk of personal injury, do
not add cold water to the decanter if the decanter is already hot. Allow the decanter to cool
before using.
1 level tablespoon (tbsp) = 5 gr./0.17 oz.
1 cup = 5 fl. oz. of brewed coffee
Use more or less coffee to suit your taste
!
(Figure 1 – Set Delay)
(Figure 2 – Adding water
and ground coffee)
B R E W I N G C O F F E E N O W
1. Press the ON Button to begin the brewing cycle. The green indicator light will turn on to signal
that the coffeemaker is brewing. When the brewing cycle
is complete the coffeemaker switches over to the warming mode.Your coffeemaker will keep
your coffee hot for 1 hour, then automatically shut off. To turn the coffeemaker off, push the
OFF button.
While the coffee is brewing, the Pause ’n Serve feature allows you to sneak a cup of coffee
from the decanter. REPLACE THE DECANTER ON THE WARMING PLATE WITHIN 30 SECONDS
TO PREVENT OVERFLOW AND POSSIBLE INJURY.
If the brew basket overflows or fails to empty into the decanter, do not
open the brew basket. Turn off the coffeemaker. Unplug the coffeemaker
and wait for the contents to cool before handling.
2. After the used coffee grounds have cooled, carefully discard them.
3. Make sure the decanter is empty before starting to brew coffee.
4. Be sure to turn your coffeemaker off when no longer using it.
B R E W I N G C O F F E E L AT E R
1. You must first set the time when you would like the coffeemaker to begin brewing your coffee
as described in “Setting the Clock and the Delay Brew Timer” section.
2. Prepare your coffeemaker as described in “Adding Water and Ground Coffee” section.
3. To activate DELAY BREW and program your coffeemaker to brew coffee at a later time, press
the Delay Brew button. The DELAY indicator will appear on the digital display.
The coffeemaker is now set to automatically brew coffee at the pre-set later time.
4. At the pre-set time the DELAY indicator will go off, indicating that brewing has started.
5. The coffeemaker warming plate will keep your coffee hot for 1 hour and then
automatically turn off.
As a safety feature, your coffeemaker will NOT start again automatically the next day.
If you want your coffee to brew at the same time the following day, simply add a
new filter, coffee and water and set DELAY BREW, by repeating Steps 2 and 3 above.
To cancel DELAY BREW: Press the OFF button. The DELAY indicator will disappear.
!
English 5 English 6