After-sales service, Installation – Smeg FR238APL User Manual

Page 8

Advertising
background image

19

AFTER-SALES SERVICE

Before contacting After-Sales Service:
1.
See if you can solve the problem yourself with the

help of the “Troubleshooting guide”).

2. Switch the appliance on again to see if the

problem persists.
If it does, switch off and wait for about an hour
before switching on.

3. If the problem persists after this course of action,

contact After-sales Service.
Specify:

the nature of the problem,

the model,

the Service number (the number after the word

SERVICE on the data plate on the inside of the
appliance),

your full address,

your telephone number and area code.

Note: The direction of door opening can be

INSTALLATION

Install the appliance away from heat sources.

Install the appliance in a dry, well-ventilated place.

Do not obstruct the top and bottom vent zones.

Clean the inside (see chapter “How to clean the
refrigerator compartment”).

Fit the accessories supplied.

Electrical Connection

Electrical connections must be made in
accordance with local regulations.

Voltage and power consumption are indicated on
the rating plate (at the side of the crispers).

Freestanding appliances (not built-in)

Fit the spacers (if supplied) on the rear of the
condenser positioned at the back of the appliance
(see figure).

To optimize appliance efficiency, leave a 5 cm gap
above the appliance and make sure that adjacent
kitchen units are sufficiently distanced to allow air
circulation.

Ensure that the appliance is level, using the front
adjustment feet if necessary.

Regulations require that the appliance is
earthed. The manufacturer declines all
liability for injury to persons or animals and
for damage to property resulting from
failure to observe the above procedures and
reminders.

If the plug and socket are not of the same type,
have the socket replaced by a qualified
electrician.

Do not use extension leads or adapters.

Disconnecting the appliance

It must be possible to disconnect the appliance by
unplugging it or by means of a two-pole switch
fitted upline of the socket.

63633043GB.fm Page 19 Saturday, March 5, 2005 3:25 PM

Advertising