Sony CPD-17SF2T - Manual (Page 3)

3
EN
Table of Contents
Introduction .............................................................................. 3
Precautions ...............................................................................3
Getting Started .........................................................................4
Using Your Monitor ................................................................ 4
Adjustments .............................................................................. 5
Entering New Timings ............................................................ 7 Power Saving Function ........................................................... 7
Plug and Play ........................................................................... 8
Use of the Tilt-Swivel .............................................................. 8
Damper Wire ............................................................................ 8
Specifications ............................................................................ 8
Troubleshooting ....................................................................... 9
Introduction
Congratulations on your purchase of a Sony Multiscan
15sf
II /17sf II !
This monitor incorporates over 25 years of Sony experience
with Trinitron display technology, ensuring excellent
performance and outstanding reliability. The Multiscan
15sf
II /17sf II ’s wide scan range (31 – 65 kHz), together with
Digital Multiscan Technology, allows it to sync to any video
mode from standard VGA through 1024
×
768 at 76 Hz (1280
× 1024 at 60 Hz). In addition, its two factory preset color
modes and one user adjustable color mode give you
unprecedented flexibility in matching on-screen colors to
hard copy printouts. Furthermore, the Multiscan 15sf
II /
17sf II feature digital controls, raster rotation, power saving,
low emissions, and much more. All together, it delivers
incredible performance with the quality and support you
can expect from Sony.
Precautions
Installation
• Prevent internal heat build-up by allowing adequate air
circulation. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes.
• Do not install the unit near heat sources such as radiators
or air ducts, nor in a place subject to direct sunlight,
excessive dust, mechanical vibration or shock.
• Do not place the unit near equipment which generates
magnetism, such as a converter or high voltage power
lines.
Maintenance
Clean the cabinet, glass panel and controls with a soft cloth
lightly moistened with a mild detergent solution. Do not use
any type of abrasive pad, scouring powder or solvent, such
as alcohol or benzine.
Warning on Power Connection
•
Use the supplied power cord.
For the customers in U.S.A.
If you do not do this, this monitor will not conform to
mandatory FCC standards.
For the customers in UK.
If you use the monitor in UK, please use the supplied UK
cable with UK plug.
for 100 to 120 V AC for 240 V AC only for 220 to 240 V AC
•
Before disconnecting the power cord, wait for at least
30 seconds after turning off the power switch to allow for
the discharging of static electricity on the CRT display
surface.
• After the power has been turned on, the CRT is
demagnetized for approximately 5 seconds. This generates
a strong magnetic field around the bezel which may affect
the data stored on magnetic tape or disks near the bezel.
Place such magnetic recording equipment and tapes/disks
at a distance from this unit.
The socket-outlet shall be installed near the equipment
and shall be easily accessible.