Sharp XG-NV4SU - Manual (Page 14)

Operation
E-13
i
Basic Operations
i. Checking the Input Mode
Press INPUT SELECT on the projector or IN-
PUT CHECK on the remote control. The current
input mode will be displayed on the screen for 4
seconds.
j. Adjusting the Volume
Press VOLUME (VOL) ם/מ on the projector or
the remote control. The number of displayed
segments (0–60) increases or decreases as the
volume is raised or lowered.
To temporarily turn off the sound
Press MUTE on the projector or the remote control.
To turn the sound back on
Press MUTE once again.
k. Turning off the Power
1. Press POWER OFF on the projector or the
remote control. The screen on the left will
appear.
2. To turn off the power, press POWER OFF
again while the screen is displayed. The
power is now temporarily turned off.
• If you accidentally pressed POWER OFF and do not
want to turn off the power, wait until the screen disap-
pears.
When POWER OFF is pressed twice, the POWER
indicator will light up red and the cooling fan will
run for about 90 seconds. The projector will then
enter standby mode.
The power can be turned on again by pressing
POWER ON on the projector or the remote control.
When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator light
green.
• When the main power is off on the projector, the power
cannot be turned on from the remote control.
On-screen
Display
Mac
k
T U R N P O W E R O F F ?
Y E S : P R E S S
N O : P L E A S E W A I T
A G A I N
j
V O L U M E
3 8
or
OFF
XG-NV4SU (E)-b 98.10.19, 5:36 PM 13