Connecting a vcr – Samsung DynaFlat TX R3265 User Manual
Page 15
I
N S TA L L AT I O N
English - 15
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna
or a cable TV system (according to the instructions on pages 11~14).
1
Connect a coaxial cable between the
“ANT 1 IN ” terminal on the TV and the
antenna out terminal on the VCR.
A coaxial cable is usually included with
a VCR. (If not, check your local
electronics store).
2
Connect a set of audio cables between
the “AV IN 1 (L, R)” (or “AV IN 2/3 (L,
R)”) jacks on the TV and AUDIO OUT
jacks on the VCR.
If you have a mono VCR, connect
L(mono) to VCR audio out using only
one audio cable.
3
Connect a video cable between the “AV
IN 1 (VIDEO)” (or “AV IN 2/3 (VIDEO)”)
jack on the TV and the VIDEO OUT jack
on the VCR.
Refer to your VCR’s instructions for
more information about how to view
your VCR tape.
TV Rear Panel
• Also, you can connect to “AV IN 1” on the side panel of TV.
K61A_AA03447B_00Eng 3/11/05 4:26 PM Page 15