Woodstock D3108 - Manual (Page 2)

Step 2. Mount the extension rail and rail support
to the table saw, parallel to the surface of the table
before beginning. Note—the right-hand table
saw wing must be removed before you attempt to
install the extension table.
Step 3. Place the extension table upside down.
Step 4. At the corners of one end of the table,
position each leg upright 90˚ to the bottom of the
table, and mount the legs with (8) #8 x
5 ⁄
8
" wood
screws into the bottom of the table.
Step 5. Secure the braces to the legs with the (2)
3 ⁄
8
"-16 x 3 ⁄
4
" hex bolts and (2) 3 ⁄
8
" flat washers.
Step 6. Secure the braces to the table with the
(2) 1 ⁄
4
" x 3 ⁄
4
" self-tapping screws and (2) 1 ⁄
4
" flat
washers.
Step 7. Thread the (2) 1 ⁄
2
"-12 hex nuts onto each
1 ⁄
2
"-12 foot, then thread the feet onto the end of
the legs.
Step 8. With a helper, place the extension table
(with attached legs) upright between the fence
rails, so that the side of the table without legs butts
up against the edge of the table saw table.
Step 9. Clamp the extension table to the rails to
hold it in position.
Step 10. Use a straightedge to make sure the
extension table is even with the saw table across
its entire length.
Step 1. Carefully remove the box contents, and
lay them out for identification. You should have:
Extension Table .......................................1
Leg ..........................................................2
Leg Brace ................................................2
Hardware Bag
-Wood Screw #8 x 5 ⁄
8
" ......................8
-Self-Tapping Screw 1 ⁄
4
" x 3 ⁄
4
" ..........2
-Flat Washer 1 ⁄
4
" ................................2
-Hex Bolt 3 ⁄
8
"-16 x 1 3 ⁄
4
" ....................8
-Flat Washer 3 ⁄
8
" ...............................22
-Hex Nut 3 ⁄
8
"-16 ................................8
-Hex Bolt 3 ⁄
8
"-16 x 3 ⁄
4
" ......................2
-Hex Nut 1 ⁄
2
"-12 ................................2
-Foot 1 ⁄
2
"-12 unc ................................2
In the event that any hardware is missing, please
feel free to contact our customer service depart-
ment, or for the sake of expediency, you can find
these common items at your local hardware store.
Thank you for purchasing Woodstock
International’s Table Saw Extension Table. This
table is designed to fit most 27" wide table saw
extension kits.
Woodstock is pleased to provide these instructions
to assist in the installation process. They represent
our effort to offer the finest documentation avail-
able. If you feel that there are areas which could
be improved, we encourage you to write us with
your comments at the following address:
Technical Documentation
Woodstock International, Inc.
P.O. Box 2309
Bellingham, WA 98227
Tel: (360) 734-3482
Fax: (360) 671-3053
INTRODUCTION
ASSEMBLY