Sony GV-D200E - Manual (Page 84)

84
The tape which is recorded in the
Hi8/standard 8 system is not
played back correctly.
The date search does not work
correctly.
No sound or only a low sound is
heard when playing back a tape.
The power does not turn on.
You cannot playback.
There are horizontal lines on the
picture or the playback picture is
not clear or does not appear.
The picture which is recorded in
the Digital8 system is not played
back.
You cannot record.
You cannot record in the LP mode.
The % and Z indicators flash and
no functions except for cassette
ejection work.
The cassette cannot be removed
from the holder.
English
Troubleshooting
If you run into any problem using your VCR, use the following table to troubleshoot the problem. If
the problem persists, disconnect the power source and contact your Sony dealer or a local authorized
Sony service facility. If “C:ss:ss” appears on the monitor screen, the self-diagnosis display function
has worked. Refer to “Self-diagnosis display” (p. 86).
Symptom Cause and/or Corrective Actions
• The AC power adaptor is not connected to the mains.
c Connect the AC power adaptor to the mains (p. 10).
• The battery pack is not installed, or is dead or nearly dead.
c Install a charged battery pack (p. 11 - 13).
• The POWER switch is not set to ON.
c Set it to ON (p. 15).
• The tape has run out.
c Rewind the tape (p. 16).
• The video head may be dirty.
c Clean the heads using a Sony V8-25CLD cleaning cassette
(not supplied) (p. 96).
•The stereo tape is played back with HiFi SOUND set to 2 in the
menu settings.
c Set it to STEREO (p. 67).
• AUDIO MIX is set to ST2 side in the menu settings.
c Adjust AUDIO MIX (p. 67).
• The tape has a blank portion between recorded portions
(p. 37).
• PB MODE is set to / in the menu settings.
c Set it to AUTO (p. 67).
• Set PB MODE to / in the menu settings (p. 67).
• The POWER switch is not set to ON.
c Set it to ON (p. 15).
• The tape has run out.
c Rewind the tape or insert a new one (p. 14, 16).
• The write-protect tab is set to expose the red mark.
c Use a new tape or slide the tab (p. 14).
• The tape is stuck to the drum (moisture condensation).
c Remove the cassette and leave your VCR for at least 1 hour
to acclimatize (p. 95).
• The tape is the standard 8 tape.
c Use Hi8 /Digital8 tapes (p. 70).
• The power source is disconnected.
c Connect it firmly (p. 10).
• The battery is dead.
c Use a charged battery pack (p. 11-13).
• Moisture condensation has occurred.
c Remove the cassette and leave your VCR for at least 1 hour
to acclimatize (p. 95).