Soundstream Technologies PICASSO Stereo Amplifier - Manual (Page 10)

10
WIRING
POWER AND GROUND
To ensure maximum output from your REFERENCE Class A PICASSO amplifier, use high quality, low-loss power
and ground cables. The PICASSO amplifier will accept up to 4 gauge power and ground cables. Determine from the
chart below the minimum gauge power and ground wire for your application.
INSTALLATION STEP 3
up to 10’ up to 20’
PICASSO PICASSO Soundstream Power40 or Power80
(4 or 8 ga.)
Soundstream Power40
(4 ga.)
CIRCUIT BREAKERS/FUSES
INTERNAL
The PICASSO amplifier is fused with a 30 Amp automotive-type fuse. Never replace the fuses with a higher value
than what is supplied. This may result in amplifier damage and will void the warranty! In the event of
blown power supply fuses, the “Fault” indicator on the top panel will light. The fuse is accessible on the front of
the amplifier.
EXTERNAL
Like all audio components, the PICASSO amplifier must be fused near the battery. A fuse or circuit breaker must be
located within 18” of the battery. This will prevent a fire in the event of a shorted cable. A 40 Amp fuse is
recommended.
REMOTE TURN-ON
Connect the “Remote” to the turn-on lead from the source unit. When +12 volts is received, the amplifier will turn
on.
SIGNAL CABLE
Use a high-quality cable that will be easy to install and has minimal signal loss to guarantee optimum
performance. Soundstream’s DL1 and SL1 are ideal.
SPEAKER CABLE
The REFERENCE Class A PICASSO amplifier will accept up to 8 gauge speaker cable. Use a high quality, flexible,
WIRING DIAGRAM