San Jose Navigation GPS Mobile Locator GM-158-USB - Manual (Page 6)

Operating Procedure
Caution
DO NOT TRY TO DO STEPS, WHILE VEHICLE IS IN MOTION.
AND KEEP YOUR EYES ON THE ROAD
Step 1: Before installing the USB driver to your computer, please don’t plug your GPS USB
product to your computer.
Step 2: Place the CD attached in the package into your CD-ROM drive.
Step 3: Browse it and choose USB Driver/Windows 95-98-2000-XP folder.
Step 4: Click the setup file and press “ Next”
Step 5: Choose the Remove option to remove the previous version of the driver if there’s any.
If there’s not, please follow the instructions from step 8.
Step 6: When the removal is done, the system asks you to reboot your computer, please
choose “ Yes” before you install the newer version of the USB driver.
Step 7: After restart your computer, browse the CD, choose the Windows folder and click the
setup file again.
Step 8: Press” Next”, and it will thoroughly and automatically install the USB driver to you
computer.
Step 9: When it’s done, Plug your GPS USB series product into your computer.
Step 10: The screen shows” detect a USB-serial controller device”.
Step 11: The system will find its corresponding driver automatically.
Step 12: When it’s done, right click “ My computer icon” then click “system properties” and
find “device manager”.
Step 13: Find “Ports (Com & Lpt)”, browse it and find “Prolific USB-to-serial Com Port
COM X)” X might be a number depending on your computer’s Com Port’s
situation.
Step 14: Indicate Com port number when you try to use your USB-GPS product as a GPS
device.