Smeg PL60XME - Manual (Page 9)

User instructions

SETTING THE WASHING PROGRAM
To select the most suitable washing program, refer to the table below
which indicates the recommended washing according to dish type and
the degree of soiling.
After using the table to identify the most appropriate washing program,
turn the PROGRAM SELECTION knob (1) (see section "3. Description
of the controls") to set the program of choice by aligning the pointer with
the program number.
AMOUNT OF
DETERGENT
DURATION CONSUMPTION
SELECTOR
AND CYCLE
TYPE AND
DEGREE
OF DIRT
ON DISHES
PROGRAM
SEQUENCE
GRAMS MINUTES
(2)
WATER
LITRES (1)
POWER
KWh (2)
1
SOAK
Pans and dishes
pending
completion of the
load
Cold prewash
_
6' 4
_
2
INTENSIVE
65°C
Very dirty pans and
dishes, even with
dried-on dirt
Cold prewash
Wash at 65°C
2 cold rinses
Rinse at 68°C
Dry
30 90' 22 1,55
3
NORMAL
60°C
(*) EN 50242
Pans and dishes
with normal dirt
Cold prewash
Wash at 60°C
Cold rinse
Rinse at 68°C
Dry
30 75' 19 1,44
4 RINSE
Dishes for rinsing
and drying
Cold rinse
Rinse at 68°C
Dry _
45' 11 0,85
Only run the soak program with half loads.
(*) Reference program as per EN 50242 standard.
(-) Not present.
(1) Average power consumption with the softener set on level 2.
(2) The cycle duration and power consumption may vary according to the water and room
temperatures, and the type and amount of dishes.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.