Sunbeam EM5600 - Manual (Page 9)

Using the control panel
Power
Press the ‘POWER’ button once to turn the
espresso machine on. The light located on
the power button will illuminate red and
the temperature indicator line on the LCD
will start to flash from symbol; this is to
indicate that your espresso machine is on
and is heating up.
Note: Before turning on the espresso machine
ensure that the operating dial on the side of
the espresso machine is in the off position.
Depending on the function selected, the
temperature line on the LCD will track
around to either the espresso or steam
temperature setting. When the espresso
machine is heated and ready to use 'READY'
will appear on the LCD.
Note: Remember that if 'READY' is not
displayed on the LCD the espresso machine
is adjusting the temperature of the heating
system.
To turn the espresso machine off, simply
press the power button.
Clock
Note: The clock will automatically begin
keeping time if the correct time is not set.
The correct time does not need to be set to
operate the espresso machine. To set the
clock simply press the 'H' button to select
the hour, ensuring that AM/PM appears
correctly and 'M' button to select the
minutes.
Note: Holding down either the 'H' or 'M'
buttons will allow for rapid time change.
Espresso/Hot water
When the espresso machine is switched on
and the espresso machine is in espresso/hot
water mode, the red light on power button
and the orange light on the button will be
illuminated.
Note: Should the espresso machine not be
in espresso/hot water mode, so the orange
light on button is not on, the coffee
maker needs to press the button to activate
the espresso/hot water mode. By design the
temperature of the espresso machine will
adjust as necessary.
7