Sony DIRECTV RECEIVER SAT-W60 - Manual (Page 11)

Connecting Your Satellite Receiver
11
Step 3: Connecting Your TV Set
VHF / UHF
AUDIO
L
R
(MONO)
VIDEO
IN
VIDEO 1 VIDEO 2
TV
S VIDEO
Satellite Receiver
1a
1b
1c
If your TV has A/V input jacks
Connect the VIDEO OUT jacks on your Satellite Receiver to the
A/V input jacks on your TV using the supplied A/V cable. (Be sure to match the
colors on the jacks with the colored plugs on the A/V cable.) If your TV has only
one audio input, connect it to the L(MONO) jack on the Satellite Receiver.
If your TV has an S-Video input
Use an S-Video cable instead of the yellow video connection. S-Video cable is
supplied.
If your TV does not have A/V jacks
Connect the VHF/UHF OUT jack to the VHF/UHF input jack on your TV using
coaxial cable. Set the CH3/CH4 switch to the channel that does not carry off-air
broadcasts in your area.
1a
1b
1c
Note
With this connection, your input source
is channel 3 or channel 4 depending on
how you set the CH3/CH4 switch on the
Satellite Receiver.