Sirius Satellite Radio SIR-GM1 - Manual (Page 5)

5 SIR-GM1 Operation and Installation Guide 5 SIR-GM1 Installation Guide
CAUTION
This symbol means important
instructions. Failure to heed them
can result in injury or material
property damage.
HALT USE IMMEDIATELY IF A
PROBLEM APPEARS. Failure to do so
may cause personal injury or damage
to the product. Return the unit to your
authorized retailer or nearest service
center for repairing.
INSTALL THE WIRING SO THAT IT IS
NOT CRIMPED OR PINCHED BY
SCREWS OR SHARP METAL EDGES.
Route the cables away from moving parts
or sharp pointed edges. This will prevent
crimping and damage to the wiring. If the
wiring must pass through a metal hole,
be sure to use a rubber grommet to
prevent the wire’s insulation from being
cut by the metal edge of the hole.
USE THE SPECIFIED ACCESSORY
PARTS AND INSTALL THE PRODUCT
SECURELY. Be sure to use only the
specified accessory parts. Use of non-
specified parts may damage this unit
internally or may not securely install the
unit in place. This may cause parts to
become loose, resulting in hazards or
product failure.
USE CAUTION IF YOU NEED TO
DISCONNECT THE BATTERY
TERMINAL. Please consult the
vehicle’s owner’s manual or a service
technician prior to removing the battery
positive or ground connection, as it may
cause damage to the vehicle’s electrical
system or require reprogramming of the
vehicle’s computer-controlled devices.
The way the SIR-GM1 is installed and
used in your vehicle will vary depending
on several factors including the make,
model and year of the vehicle as well
as the factory-installed options. Please
refer to the information below for
information on the proper method of
SIR-GM1 installation.
If your vehicle is pre-wired for satellite
radio, then you should install the SIR-
GM1 in the factory satellite radio tuner
location using the existing wiring and
the ‘factory harness adapter’. Please
refer to the factory service manuals for
appropriate installation instructions.
If your vehicle is not pre-wired for
satellite radio, but it is compatible with
the SIR-GM1, then you must use the
provided T-harness to connect to the
back of your factory headunit.
COMPATIBILITY