Stoelting Endura 131G - Manual (Page 29)

21
ERROR CODE SYSTEM
*Refer to Page 19 for Troubleshooting.
** If the Clean switch is operated three times within 10 seconds, this will
cause the Push-To-Freeze light to flash and the clean function will be
disabled for 10 minutes. The power switch must remain on or the 10
minute timer will not time out. A flashing clean light is not an error.
NOTE
Flashing CLEAN light is not an error. It indicates the freezer is in the CLEAN mode. To exit, turn the OFF-ON
switch to the OFF position.
CODE P.T.F. LIGHT FLASHES MEANING
01 Sequence of one * Program board
02 Sequence of two * Power board
03 Sequence of three * Low torque error
04 Sequence of four ** Clean error
05 Sequence of five * Barrel sensor
06 Sequence of six * Hopper sensor
07 Sequence of seven * Drive motor