Scientific Atlanta AllTouch 573480 - Manual (Page 8)

573497 Rev B 8
Setting up the remote control to operate other devices
You can use the
AUX
button on your AllTouch Remote Control to set up
your:
• Cable digital audio receiver
• CD player
• Home automation device
To make the remote control work with other devices, follow this
procedure.
1. Find the code for your brand of device in the back of this guide.
You may find more than one code for your particular brand. Start
with the first choice.
2. Press and release
AUX
, then hold down
SET-UP
until
the red light blinks twice.
Note: You may need to wait a few seconds for the
red light to blink twice.
3. Enter your 3-digit device code–the red light should
blink twice again. (If the red light does not blink
twice, return to step 1 and try again.)
4. Point your AllTouch Remote Control at your device
and press
POWER
.
5. Did your device turn off (or on)?
• If yes, you are finished setting up your device.
Write your code on page 31.
• If no, go to step 6.
Note: You may want to try several functions of your device to
verify operation. Button operation (for example, CH ▲▼, LAST,
INFO, etc.) will depend on the AUX device programmed.
6. If your device did not respond, repeat steps 2 through 5 trying all
of the codes (one at a time) under your brand.
7. If your device still did not respond, turn to All Search on page 10
and follow the steps.
VCR
1
4
7
2
5
8
0
3
6
9
AUX
V
O
L
S E L E C
T
REW
PAUSE REC STOP
PLAY FF
SET-UP BYPASS
MENU INFO
PPV
PREV. DAY NEXT DAY
MUTE
LA
ST
FAV
POWER
TV
CBL
C
H
T6056
SET-UP
AUX
G U
ID
E
B A C