Ardo FLSN - Manual (Page 6)

6
SM2714
WASHING INSTRUCTIONS
Detergent dispenser:
1 Prewash
Softener
2 Wash
Control panel:
A Prewash button
B No spin
C Turbo button
D Start button
E Programme selector knob
F Start / END LED
A C B D F E
CORRECT WASHING PROCEDURE
Before using the washing machine, make sure that it has been installed correctly as reported
in the instruction book.
Daily use
1. Before placing the washing in the washing machine, make sure that there are no hard pointed
objects in the pockets (nails, screws, coins, pins, stones, etc.) as these can damage both the
clothing and the appliance.
2. To improve the performance of the wash, place the washing loosely in the drum without compressing
it. Do not overload the machine. A full load of particularly absorbent material such as bathrobes and
towelling can unbalance the washing machine during the spin phase. The automatic load-balancing
system distributes the washing as evenly as possible and automatically sets the best spin speed
to reduce vibrations to a minimum.
3. Close the door, making sure that no washing has become trapped between the door and the
gasket.
4. Place the correct amount of detergent in the appropriate dispenser 2. When using a liquid
detergent, insert the partition supplied. If the Prewash function is required, add detergent to
compartment 1. Add softener to the compartment marked with the symbol . After adding the
detergent, gently close the detergent drawer.
5. Use knob I to select a wash programme suitable for the type of fabric, following the instruc-
tions reported in the Programme Table.
6. Buttons A, B and C are used to select the extra functions. The options selected are indicated
by the relative LED’s. The duration of the wash cycle varies according to which options have been
selected.
7. To start the wash cycle, press the Start button D. After a few seconds, the fl ashing Start LED
will change to a fi xed light to indicate that the wash programme has started.
8. At the end of the wash cycle, the LED END will fl ash. Place knob I in the Stop position and
open the door to remove the washing.
9. The washing machine can be reset at any time by placing knob I in the Stop position.
GB