Smeg FD54APXNF - Manual (Page 5)

UK - 3 -
Installation and Switching On The Appliance
• This appliance is connecting to 220-240V and 50 Hz.
• You can offer help from the service to install and switching on the appliance without
any cost.
• Before making the connection to the power supply,ensure that the voltage on the
name plate corresponds to the voltage of electrical system in your home.
• If the socket does not match the refrigerator plug, replace the plug with a suatible
one (at least 16 A)
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact, we suggest you call an electrician for assistance.
• Manufacturer is not responsible for failure to complete the ground connection as
described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the refrigerator far from heat sources and in a well-venti-
lated position. The refrigerator should be at least 50 cm from
radiators,gas or coal stoves and 5 cm far from electrical stoves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another refrigerator or freezer,
observe a miminum distance of 2 cm to prevent condensation.
• Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good per-
formance.
• The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should
be cleaned with a solution of water and liquid soap ; the inside
of the appliance with sodium bicarbonate dissolved in luke-
warm water. After drying replace all the accessories.
• Supply cable must be changet by technical supporters.
Before Switching On
• Wait after 3 hours before plugging the appliance in to the main power
to ensure proper performance.
• There can be an odor when you first switch on the appliance. It will
disappear after the appliance starts to cool.