Snapper SB2000M - Manual (Page 5)

-- 5 --
SHOULDER STRAP ADJUSTMENT
1. Hold the unit as shown with the muffler side
facing away from your body and clothes.
2. Pass the shoulder strap over your head
and onto your right shoulder.
3. Extend your left arm toward the rear of the
vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger.
5. Make sure air flows freely from the elbow
tube into bag. If bag is kinked, the unit will
not operate properly.
OPERATION
KNOW YOUR BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
Choke Lever
Fuel Mix
Fill Cap
Starter
Rope
Throttle
Lever
Spark Plug
Blower
Tube
Primer Button
Rear
Handle
Lower
Vacuum Tube
Upper
Vacuum Tube
Vacuum Bag
Elbow Tube
THROTTLE LEVER
The THROTTLE LEVER is used to select the
desired engine speed and to stop the engine.
Move the throttle lever to the
position for
full speed operation. Move the throttle lever
to the
position for idle speed. To stop the
engine, move the throttle lever to the STOP
position.
PRIMER BUTTON
The PRIMER BUTTON removes air from the
carburetor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate primer button
by pressing it and allowing it to return to its origi-
nal position.
CHOKE LEVER
The CHOKE helps to supply fuel to the engine
to aid in cold starting. Activate the choke by
moving the choke lever to the FULL CHOKE
position. After engine attempts to start, move the
choke lever to the HALF CHOKE position.
Once engine starts, move choke lever to the
RUN position.
For Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com