User instructions – Smeg DWF66WH User Manual
Page 13
User instructions
34
ADJUSTING THE WATER SOFTENING SYSTEM
The dishwasher is equipped with an electronic device for adjusting the water softening setting
according to the hardness of the water. To adjust the water softening setting, proceed as follows:
•
Press down the HALF LOAD (3) button for a few seconds until the bS symbol appears on the
INFORMATION DISPLAY (4).
•
Press the START/STOP (5) button to access the water softening settings (the current setting
appears on the information display).
•
Press the HALF LOAD (3) button again to select the desired hardness setting (h1, h2... h5).
Choose the value by referring to the “Water hardness table”.
•
Press the START/STOP (5) button to exit the set-up mode.
WATER HARDNESS TABLE
WATER HARDNESS
German Degrees (°dH)
French Degrees (°dF)
SETTING
0 - 4
0 - 7
.h 0
5 - 15
8 - 25
.h 1
16 - 23
26 - 40
.h 2
24 - 31
41 - 60
.h 3
32 - 47
61 - 80
.h 4
48 - 58
81 - 100
.h 5
Contact your local water board for information on the hardness of your water supply.