Sony WEGA KV-XJ29 - Manual (Page 21)

Additional Information 21
Troubleshooting
If you find any problem while viewing your TV, please check the following guide. If
any problem persists, contact your Sony dealer .
Possible cause Symptom Solutions
• Check the antenna cable and connection
on the TV, VCR and on the wall.
• Press SELECT until “MANUAL
PROGRAM” appears on the screen, then
preset the channel again.
• Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
• Adjust the antenna direction. Contact a
Sony dealer for advice.
• Try using a booster.
• Turn off or disconnect the booster if it is
in use.
• If the sound of all the channels are noisy,
check the TV system (TV SYS) setting,
then press AUTO PROGR to preset the
channels again.
• If the sound of some channels are noisy,
select the channel, then select the
appropriate TV system (TV SYS).
• Check the power cord, antenna and the
VCR connections.
• Press ?/1 (power).
• Press ! (main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
• Connection is loose or
the cable is damaged.
• Channel presetting is
inappropriate or
incomplete.
• The antenna type is
inappropriate.
• The antenna direction
is inappropriate.
• Signal transmission is
low.
• Broadcast signals are
too strong.
• The TV system setting
or channel presetting
is inappropriate or
incomplete.
• The power cord,
antenna or VCR is not
connected.
• The TV is not turned
on.
Page
4
10
–
–
–
–
9
10
4
13
12
Snowy picture
Noisy sound
Distorted picture
Noisy sound
Good picture
Noisy sound
No picture
No sound
Additional Information
continued