Sunbeam 400 - Manual (Page 6)

Before using your Oskar 400
• Wash the processing bowl, cover, continuous
flow attachment and all attachments in warm
to hot water using a mild detergent. Dry each
part thoroughly before use.
• Before you assemble the Oskar 400, ensure
that the power cord in unplugged.
Using the processing bowl and cover
1. Set up the motor base facing you on a dry,
level surface.
Note: The tallest side of the motor housing
to the rear.
2. Place the processing bowl over the drive shaft
and rotate the container until it drops down
evenly onto the base. Turn the processing
bowl anti-clockwise firmly until it ‘locks’ into
place (1).
3. Fit the processing blade onto the drive shaft,
rotating it slightly until it settles into place (2).
4. Place food in the food processor bowl.
5. Place the processing bowl cover on the
processing bowl so that the large locking tab
on the cover is to the right side of the bowl,
near the horizontal slot at the back of the
processing body (3).
6. Plug in the food processor and turn the
power ‘ON”.
7. Turn the processing cover to the left (anti-
clockwise), this will engage the automatic
switch and the food processor will turn on (4).
Note: Unless the locking tab on the processing
bowl cover is engaged, the unit will not turn on.
Using your Sunbeam Oskar 400.
6
(1)
(2)
(3)
(4)
Large locking tab
Horizontal
slot