Speco Technologies VM-HT19LCD - Manual (Page 11)

11
AUTO: Auto-optimize displaying picture under PC mode.
Enter:
This “ Auto” Button can be either “Enter” function in OSD Menu)
CCD Mode:
Under AV/1 / AV2 / S-Video press Auto can be changed to
CCD/Video mode toggle.
MENU:
OSD menu ON / OFF control.
(EXIT Item)
ADJUST:
Increase or decrease the value on OSD menu.
Up : Increase value or turn ON / OFF function.
Down:
Decrease value or turn ON / OFF function
SOURCE:
Select input signal from AV1, AV2, S-Video or VGA (PC).
POWER: Monitor power ON / OFF. At OFF mode, monitor will be at standby status.
Green Light:
ON Mode
Orange Light:
Power Saving (Refer to not below)
Red Light: OFF Mode
Note: 1. AV1, AV2, S-Video: When there is no input signal, LCD monitor
will into Power Saving mode after 60 seconds.
2. VGA: When there is no input signal, LCD monitor will into power
saving mode after 5 seconds.
3. PIP: When there is no signal on both input sources, LCD
monitor will into Power Saving mode after 120 seconds.
Setup your Monitor