Sony GDM-17SE2T - Manual (Page 4)

4
This monitor will sync with any IBM or compatible system
equipped with VGA or greater graphics capability.
Although this monitor will sync to other platforms,
including Macintosh and Power Macintosh system, a cable
adapter is required. Please consult your dealer for advice on
which adapter is suitable for your needs.
Step 1: With the computer switched off, attach the video
signal cable to the monitor (HD15/5 BNC’s) and
attach the other end to the video card.
Getting Started
to
VIDEO IN R/G/B
SYNC IN HD/VD
to video output
to video output
Macintosh Adapter
(supplied)
Apple Computer
IBM or Compatible Computer
IBM or Compatible Computer
Apple Computer
to video output
to video output
Macintosh Adapter
(supplied)
to HD15
Video signal cable
(supplied)
Video signal cable
(not supplied)
Note :
•
Use HD15 (Female)-HD15(Male without No.9 pin)
adapter (not supplied) for current DOS computer which
has no compliance of DDC 2AB and its No.9 pin is
disconnected.
•
Supplied Macintosh adapter is compatible with
Macintosh LC, Performa, Quadra and Power Macintosh
series computers. Macintosh II series and some older
version of PowerBook models may need an adapter with
micro switches.
Step 2: With the monitor switched off, attach the power
cord to the monitor and the other end to the power
outlet.
to a wall outlet
Power cord (supplied)
Step 3: Turn on the monitor and computer.
Step 4: Switch the input connector according to the
adjustment procedure on page 10.
Step 5: If necessary, adjust the user controls according to
your personal preference.
The installation of your monitor is complete. Enjoy your
monitor.
Notice
To comply with the limits of FCC Class B and IC Class B for
digital device, please attach the supplied video signal cable
for HD15 input or SMF-400 (sold separately) for BNC input.
Furthermore, each cable has ferrite cores on it.