Sun Lawn MM-2 - Manual (Page 10)

Owner’s Manual — Sunlawn MM--2
8
2. Make the same adjustment at the other end of the cutting bar.
3. Now check the adjustment using the small 0.05mm/0.002 inch
gauge (silver strip) supplied with the MM-2 (or any 0.05mm/0.002
inch feeler gauge). If the gauge is held by the cylinder blades but
the cylinder and cutting bar are not touching then the adjustment is
correct.
4. The blades may also be tested by inserting a piece of paper
vertically into the blades while turning them by hand.
Mower Cutting width: 40 cm (16 inches)
Cutting height rough (from floor): 1.0 to 2.9 inches
TECHNICAL DATA
WARNING
Blades are sharp! Be careful of injury —
handle the blades carefully to avoid
cutting yourself. Wear appropriate gloves
or hand protection.
!