Soundstream Technologies SA 164 - Manual (Page 6)

INSTALLATION STEP 2
INSTALLATION STEP 3
SELECTING INPUT MODES
The can be driven with either one or two pairs of stereo inputs. If your
source unit has front and rear outputs, you can take advantage of its fading
capability by driving the multi-channel amplifiers with two pairs of input. When
operating your Soundstream amplifier in mono, only one input is necessary.
On Soundstream amplifiers, pairs of channels may be bridged for mono operation.
To do so, simply put the stereo switch into the “mono” position and follow the
mono wiring (Right Positive goes to speaker’s positive; Left Negative goes to
speaker negative).
Stereo for normal operation.
in order to drive stereo and mono simultaneously; works well for
center channels. It can be used anytime you need a summed mono channel.
for dedicated single channel operation: ideal for driving
subwoofers. It is also used when large amounts of power are necessary for single
speakers.
In bridged mono, on/y the right channel input (per pair of
channels) is active.
STEREO
Use L R Inputs
MONO
Use R Input Only
MIXED MONO
Use L R Inputs
M O N O M O N O @ S T E R E O M O N O @ S T E R E O STEREO
For system examples and diagrams, see
WIRING
POWER AND GROUND
To assure maximum output from your amplifier, use high quality, low-loss power
and ground cables. Soundstream SA amplifiers incorporate gold-plated barrier
strips for maximum power transfer and protection from corrosion. The screw
terminals back out for use with spade ring terminals, as well as bare wire.
Determine from the chart below the minimum gauge power and ground wire for
your application.
up to 20’
64
Soundstream Power80
or Power100
Soundstream Power80
Soundstream Power80
or Power1 00
or 8 or 10 ga.)
Soundstream Power80
CIRCUIT BREAKERS/FUSES
EXTERNAL
Like all audio components, the Soundstream amplifiers must be fused near the
battery. A fuse or circuit breaker must be located within 18” of the battery. This
will prevent a fire in the event of a shorted cable. See the chart below to
determine the value of your battery fuselcircuit breaker.
(Continued on page 12)
pages
10