Simplicity SMLBC55151BV - Manual (Page 5)

3
unit assembly
Note: Please refer to Parts List for correct part identification and placement.
FRONT WHEEL ASSEMBLY
• Attach left and right caster brackets to caster wheel
using 3/8-18 x 2-1/4 bolt and lock nut. Insert bolt
through hole in bracket. Place caster wheel onto
bolt. Place other caster bracket onto bolt. Secure
with lock nut. Do not over tighten. Wheel must rotate
freely. Place caster brackets onto the threaded studs
located near the discharge on the front of the
machine. Place flat washer and lock washer on
each stud. Note: Angled edge of mounting
brackets should be upwards, with holes toward
bottom. Fasten with two 5/16-18 hex nuts. Do not
tighten.
• Check caster wheel for proper vertical alignment
(camber), adjust as necessary, then tighten nuts.
SIDE AIR DEFLECTOR
• Attach side air deflector to top of discharge
chute by aligning holes in deflector with
threaded studs in top of chute snout. Fasten
with two 5/16-18 hex nuts and split lock
washers. Note: Deflector should be angled
downward.
HANDLE ASSEMBLY
• The upper handles are shipped in the folded
storage position. To unfold, loosen two handle
knobs and rotate up to the operating position.
The upper handles are secured with four knobs.
Insert two 5/16-18 x 2 curved head bolts
through the handles directly below the two
shipping knobs. Place one internal tooth lock
washer on each of the bolts. Thread knobs onto
curved head bolts. Tighten all four knobs
securely.
1
Assembly complete. Your unit is now ready to be started and checked for proper operation.
Some minor final adjustments may be required; see the Maintenance portion of this manual.