Smeg PL115NE - Manual (Page 11)

User instructions
10
SETTING THE WASHING PROGRAM
To select the most suitable program for the dishes to be washed refer to
the table below, which indicates the most appropriate program according
to dish type and degree of soiling.
DURATION CONSUMPTION
PROGRAM SELECTION TYPE AND GRADE DIRT
PROGRESS
PROGRAM MINUTES
(2)
WATER
LITRES (1)
POWER
KWh (2)
SOAK
PANS AND DISHES
AWAITING COMPLETION
OF THE LOAD
Cold prewash 15' 6 0,03
LIGHT
DELICATE DISHES
WITH LIGHT DIRT
Wash at 45°C
Cold rinse
Rinse at 70°C
Dry
70' 15 1,15
BIO
(*)
DISHES WITH
NORMAL DIRT, EVEN
WITH DRIED-ON RESIDUES
Cold prewash
Wash at 50°C
Rinse at 64°C
Dry
180' ** **
NORMAL
PANS AND DISHES
WITH NORMAL DIRT,
EVEN WITH DRIED-ON
RESIDUES
Cold prewash
Wash at 65°C
Cold rinse
Rinse at 70°C
Dry
100' 20 1,40
ULTRA
CLEAN
VERY DIRTY PANS
AND DISHES, EVEN
WITH DRIED-ON RESIDUES
Prewash at 45°C
Wash at 70°C
2 cold rinses
Rinse at 70°C
Dry
115' 24 1,77
Only run the soak program with half loads.
The HALF LOAD OPTION (5) and DELAYED START (7) options cannot be used with the soak
program.
(*)
Reference program as per EN 50242 standard
(**) See energy label
(1) Average power consumption with the softener set on level 2.
(2) The cycle duration and power consumption may vary according to the water and room
temperatures, and the type and amount of dishes.
The ULTRA CLEAN program terminate with an extra anti-bacteria rinse that ensures a further
reduction in the bacteria level. If the temperature falls during this stage of the program (e.g.
because the door is opened or due to a power blackout), the program lights (2) flash to warn that
the anti-bacteria effect is not guaranteed.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.