SDI Technologies The Portable System For Your iPhone & iPod iP27 - Manual (Page 14)

11
Solucionando problemas
El iPhone/iPod no
carga El iPhone/iPod no está instalado
correctamente Quite el iPhone/iPod del encastre y retire la posible
obstrucción del encastre o de su iPhone/iPod. Vuelva a
colocar el iPod dentro del encastre.
El iPhone/iPod está trabado/no responde
La batería del iPod podría tener algún
inconveniente
Por favor asegúrese de que su iPhone/iPod funcione
correctamente antes de colocarlo en el encastre. Refiérase
al manual de su iPhone/iPod para mayor información.
El sonido sale
distorsionado El volumen se encuentra muy alto Baje el volumen
El sonido sale distorsionado de la unidad Si el sonido original de su iPhone/iPod era de pobre calidad,
las distorsiones y ruidos se harán más notables con los
parlantes de alta potencia. Pruebe utilizar otra fuente de
audio como un CD.
Si está utilizando un iPod de primeras generaciones o un
nano, intente bajar el volumen de su aparato. También
intente apagar el amplificador de bajos
El control remoto no
funciona Las baterías están gastadas Reemplace las baterías por nuevas
No está apuntando el control remoto
hacia el iP27 Apunte el control remoto hacia el iP27 y manténgase a
una distancia máxima de 10 pies de la unidad.
Síntoma Causa Solución
Table of Contents
Maintenance
Quick Start .................................................................................................................................................................... 1
Controls and Indicators / iP27 Display .................................................................................................................... 2
Using the iP27 ........................................................................................................................................................... 3-4
Replacing iP27 Backup Batteries ............................................................................................................................. 5
Install/Replace Batteries for Portable Use .............................................................................................................. 5
Using The Remote Control Unit ............................................................................................................................... 6
A Consumer Guide to Product Safety ......................................................................................................................... 7
Troubleshooting ...................................................................................................................................................... 8-9
Solucionando problemas ..................................................................................................................................... 10-11
Warranty Information ................................................................................................................................................ 12
Maintenance
• Place the unit on a level surface away from sources of direct sunlight or excessive heat.
• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should
be placed between it and the furniture.
• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzene, thinner
or similar materials can damage the surface of the unit.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits
provide reasonable protection against radio and TV interference in a residential area.
However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate
interference you can try one or more of the following corrective measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the radio or TV.
• Use outlets on different electrical circuits for the equipment and the radio or TV.
Consult your dealer or an experienced radio/television technician if the problem still exists.
Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the
system’s warranty and void your FCC authorization to operate it.
This Class B digital apparatus complies with Canadian ICES-003.
FCC Information
IP27BR IB