Sega 999-1108 - Manual (Page 87)

80
Attach CONNECTOR 22 to the both ends of FLEX TUBE. First, disassemble CONNECTOR
22 (Fig. 17. 2 b).
First pass the plastic nut through the flex tube. Otherwise, the following work can not be
performed and therefore, be very careful of this point.
Install the holder and then the "insert" to the end of the flex tube by turning them as in bolts and
nuts (Fig. 17. 2 c).
Tighten the plastic nut to the connector. At this time, pass the communication cable through the
flex tube ahead of time so as to allow the following work to be performed easily (Fig. 17. 2 d).
Install the flex tube into the CONNECTOR BOX HOLE. Insert the connector into the
CONNECTOR BOX HOLE, put the seal washer through and fasten the metal nut (Fig. 17. 2 e).
INSERT
CONNECTOR
FLEX TUBE
FLEX TUBE
FIG. 17. 2 b FIG. 17. 2 c FIG. 17. 2 d
PLASTIC NUT
HOLDER
PLASTIC NUT
HOLDER
CONNECTOR
INSERT
SEAL WASHER
METAL NUT
SEAL WASHER
METAL NUT
CONNECTOR BOX
COMMUNICATION CABLE
FIG. 17. 2 e
5
6
7
8
9