Samsung SPP 2040 - Manual (Page 6)

Power Cord Requirements
The power cord set (wall plug, cable and AC adapter plug) you received with your
printer meets the requirements for use in the country where you purchased your
equipment.
Power cord sets for use in other countries must meet the requirements of the
country where you use the printer. For more information on power cord set
requirements, contact your authorized dealer, reseller, or service provider.
General Requirements
The requirements listed below are applicable to all countries:
• The length of the power cord set must be at least 6.00 feet (1.8m) and a maximum of
9.75 feet (3.0m).
• All power cord sets must be approved by an acceptable accredited agency responsible
for evaluation in the country where the power cord set will be used.
• The power cord set must have a minimum current capacity of 7 A and a nominal
voltage rating of 125 or 250 volts AC, as required by each country’s power system.
This user’s guide is for both SPP-2040 Series and SPP-2020 Series.
However the instructions and pictures contained in this user’s guide are mainly for
SPP-2040 Series users. Make sure the model and serial number before reading
this user’s guide.