Sony MZ-R5ST - Manual (Page 46)

46
Error Messages
If the following messages flash in the display window of the station or the remote control,
check the chart below. The display of the recorder will flash
when a message is
displayed on the station or the remote control.
Station (remote
control)
BLANK DISC
(BLANK)
CONNECTION
ERROR (—)
DISC ERROR
(ERROR)
DISC FULL (FULL)
EDIT BUSY (BUSY)
— (LoBATT)
MEMORY OVER
(MEMORY)
NAME FULL
NO DIGITAL
SIGNAL (—)
NO DISC (No DISC)
P/B ONLY (PbONLY)
PROTECTED DISC
(SAVED)
Meaning/Remedy
•An MD with no recording on it is inserted.
b Insert a recorded MD.
•The recorder is not attached to the station securely.
b Attach it securely.
•The recorder cannot read the disc (it‘s scratched or dirty).
b Reinsert or replace the disc
•There is no more space to record on the disc (less than 12
seconds available).
b Replace the disc.
•You tried to operate the recorder while it was accessing the
recorded data.
b Wait until the message goes out (in rare cases, it may take
2–3 minutes).
•Batteries are weak.
b Charge the rechargeable battery/replace the dry batteries
(pages 36, 37).
•You tried to record when there is no indication in the display,
with the recorder placed where it receives continuous
vibration.
b Put the recorder on a stable place, and start recording
again.
•You tried to enter more than 200 characters for a track or disc
name or more than 1700 for the entire disc.
b Enter the characters within the limit.
•The recorder could not detect digital input signals.
b Make sure that the source is connected securely. Ignore
when recording analogically.
•You tried to play or record with no disc in the recorder.
b Insert an MD.
•You tried to record or edit a premastered MD (P/B stands for
”playback”.)
b Insert a recordable MD.
•You tried to record or edit on a MD with the tab in the record-
protect position.
b Slide the tab back.