Studer Innotec XPC 1400-12 - Manual (Page 13)

STUDER INNOTEC XP-COMPACT
XP-COMPACT V5.3 15/77
10 Over Temp.
For the time being
the XP-COMPACT
is out of service
because of
overheating.
11 Overload
The XP-COMPACT
is out of service
because of
overload or short-
circuit
12
Batt.
Low/High
Battery voltage is
too low Battery voltage is or was to high
13 OFF
XP-COMPACT is
turned off. Turning
it back on is only
possible manually. XP-COMPACT is for the time being
turned off. Turning it back on will
follow automatically !
14 EQUALIZE
Battery equalizing
is set
15–18
State of charge of
the battery LED 15 – Absorption time is running
25
POWER
MONITOR
Display the value of the output power in % of Pnom (in
Inverter Mode) and the charge current in Amps (in Charger
Mode).
4.4 Push buttons
19 ON/OFF
Turning the XP-COMPACT on and off (Help Button for
Programming)
20 RESET Alarm Signal off (Help Button for Programming)
21 Aux. Contact Control Aux. contact (Help Button for Programming)
4.5 Turning Knobs
22 CHARGER Adjustment for max. Charging Current
23 TRANSFER
Adjustment for Transfer Voltage Threshold (TRANSFER –
INVERTER)
24 STANDBY Adjustment for „Standby“ system
4.6 The Inverter
An Inverter is built in the XP-COMPACT, which generates a sinusoidal alternating
voltage of a very high quality. With this Inverter any 230Vac alternating voltage
appliance up to the nominal power of your XP-COMPACT can be operated. Thanks
to the generous dimensioning of the XP-COMPACT, you can operate appliances
requiring higher power than the nominal power of the XP-COMPACT for a short time.
The XP-COMPACT provides up to 3-times the nominal power to start motors.
The Inverter mode is displayed through LED 9 (Inverter). If the Inverter Mode is
disabled (see chap. 5.5) LED 9 will blink. If the LED 9 is lit, the Inverter is in operation
and you have 230Vac at the output AC OUT. The actual power of the connected
appliance is displayed on the power monitor 25 and on the Remote Control.