Sanyo Multimedia PLC-XD2600 - Manual (Page 44)

44
Setting
✔ Note:
• Auto Keystone corrects vertical distortion only,
not correct horizontal distortion.
• The Auto Keystone function cannot work when
the Ceiling feature is set On in the Setting menu
(p.49).
• Perfect correction of the image distortion cannot
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SETUP or the AUTO SET button, adjust
manually by pressing the KEYSTONE button on
the remote control or selecting Keystone in the
Setting menu (pp.23, 45).
• Fine sync, Total dots, Horizontal and Vertical
position of some computers cannot be fully
adjusted with the Auto PC Adjustment function.
When the image is not provided properly with
this operation, manual adjustments are required
(pp.30-31).
Auto setup
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point ▲▼
buttons to select one of the following options.
Off ........... Input search does not work.
On1.......... Input search works under the following situation.
– When pressing the AUTO SETUP button on
the top control.
– When pressing the AUTO SET button on the
remote control.
On2.......... Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the AUTO SET button on the
remote control.
– When pressing the AUTO SETUP button on
the top control.
– When the current input signal is cut off.*
* If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen menu is displayed.
Auto PC adj .
On. . . . . . . .Enables Auto PC Adjustment when pressing
the AUTO SET button on the remote control or
the AUTO SETUP button on the top control.
Off . . . . . . .Disables Auto PC Adjustment.
Auto Keystone
Auto . . . . . Always works and corrects keystone distortion
according to the projector's tilt.
Manual . . . .Works only when pressing the AUTO SETUP
button on the top control or the AUTO SET
button on the remote control.
Off . . . . . . .Disables Auto Keystone.
Auto setup
✔ Note:
• While Input search is set to On1 or On2, the status of Input
and Lamp are displayed every time the signal is switched.
• Only the last selected input source can be detected.
• During
Input search is in progress, If the MENU button or the
ON/STAND-BY button is pressed, Input search will stop. If
the COMPUTER 1/2 button or VIDEO or COMPONENT or S-
VIDEO button is pressed,
Input search will stop and go back
to the button's input signal.
• Input search, Auto PC adj . and Auto Keystone cannot be
set Off at the same time.
This function enables Input search, Auto Keystone correction
and Auto PC adjustment by pressing the AUTO SETUP button
on the top control or the AUTO SET button on the remote
control. Settings for those functions can be altered as follows:
Network
English
Blue
Off
On
Off
Off
Off
Computer 2
Direct on
►
►
1/2
►
Auto PC adj.
On 1
On
Auto Auto Keystone
►
On 1
On
Auto