Sony RM-AX4000A - Manual (Page 31)

31
Oper
ating
If you want to quit before
finishing
Press and hold the COMMANDER OFF button
for more than 2 seconds. The previous status
returns, and the Remote Commander turns off.
If you want to return to the
previous display
Press the BACK button or the COMMANDER
OFF button.
Notes
• When you finish setting the timer standby
mode, the “ ” mark stays lit beside the
clock. This means that one or more Timers
are activated.
• The timer program you set repeats every
week until you set the timer standby mode to
OFF (weekly timer). If you want to execute
the timer program only once, set the timer
standby mode to OFF after the execution of
the timer program.
IMPORTANT
The Timer function of this Remote
Commander is designed for use
with AV components.
Do not use the Timer function with
other components, such as an air-
conditioner or other electrical
appliances. It may cause a fire or a
serious injury.
Executing a series of
actions with just one
button
– System Control function
EPG MENU
SYSTEM CONTROL
OK
1 MORE 4 3
COMPONENT
VOLUME
BACK X PRESS
2
RECALL
LIGHT TIMER
MUTING
SYNC-UP
CHANNEL
EXIT TOOLS
ALL OFF
LEARN
NG
OFF
COMMANDER
The Remote Commander has special
buttons which can be programmed to
perform a series of actions (a macro) by
pressing just one button.
If you press the MORE button (rightmost
SYSTEM CONTROL button), all keys
sharing the same function as that
SYSTEM CONTROL button appear at the
bottom of the display. These keys are
called, “System Control keys.”
You can program a series of actions (a
macro) for each of four SYSTEM
CONTROL buttons and four System
Control keys. This is called “System
Control macro.”
How to set the System Control
function
For On-PC Setup: See the Help menu
provided in “AX Remote Editor.”
For On-Remote Setup: See
“Programming a series of actions with
just one button” on page 51.
System Control
keys
SYSTEM
CONTROL 1-4
buttons
MORE button
Continued