Southwestern Bell FT365 - Manual (Page 4)

Installation
Modular Wall Jack
A modular wall jack is required to install your FT365.
Installation of this telephone in locations with 4-prong jacks
or with hardwired outlets requires additional converters
(not included). Contact your local telephone company or
retailer concerning the proper converter.
Coil Cord Connection
Insert the coil cord into the jack located on the bottom
of the base. Connect the other end into the jack
located on the handset.
Line Cord Connection
To use both lines of a two-line telephone, two telephone numbers must be
provided by your local telephone company. If you have only one telephone
number, another line can be installed by your telephone company.
For One Two-Line Jack
Insert one plug of the 4-wire modular line cord (included) into the wall jack,
making sure it snaps firmly in place. Insert the other plug of the 4-wire line cord
into the telephone jack marked “LINE 1 + 2” (on back of base).
For Two Single Line Jacks
For two single line jacks, two separate line cords are needed for the connection.
Insert one plug of the 4–wire line cord (included) into the first telephone wall
jack. Insert the other plug of the 4–wire line cord into the telephone jack (back of
unit) marked “LINE1+2”. Insert one plug of the second line cord (not included)
into the second telephone wall jack. Insert the other plug of the second line cord
into the telephone jack marked “LINE 2”
or
6
Location of Controls
Base
5