Simplicity Jessie Vacuum Bag and Filters - Manual (Page 5)

5
Replacing Vacuum Bag and Filters
Replacing the vacuum bag
Change the vacuum bag when the full bag indicator
light is flashing RED or suction power is weak. The
bag compartment will not close without a bag in the
unit or if the bag is not properly installed.
. Open the bag compartment.
2. Pull the tab on the cardboard bag collar, which
closes the bag while removing it from the bag
holder.
3. Remove and discard the used bag.
NOTE: The HiFlow™ HEPA bag cannot be reused.
4. Slide a new bag into the bag holder until it
clicks into place.
Replacing the secondary filter
. Open the bag compartment and locate
the filter behind the vacuum bag. For
better access to the secondary filter,
remove the bag.
2. Pull the filter holder up toward you.
3. Remove the used filter and replace it with
a new filter.
4. Slide the filter holder back into place and
replace the bag.
Replacing the HEPA filter
. Push in and lift off the filter cover on the
top of the vacuum.
2. Lift out the used HEPA filter and replace
with a new filter.
NOTE: The HEPA filter cannot be washed
and reused.