Simmons Optics Spotting Scope 71-2060 - Manual (Page 3)

3
BASIC INSTRUCTIONS
uSing tHe pan arM to MoVe tHe Scope
To pan the scope side to side or up and down, first loosen the side
and/or vertical lock. Then unlock the pan arm by rotating it
counterclockwise and use it to move the scope as desired. To lock
the scope in place, rotate the pan arm clockwise and tighten the
side/vertical locks.
uSing tHe eYecup
If you wear eyeglasses, fold down the rubber eyecup if you have
difficulty seeing the entire image. After use, return the eyecup to
the fully extended position before storing the scope to ensure that
the rubber in the eyecup retains its normal shape and flexibility.
care
The lenses of your spotting scope are coated for highest light
transmission. As with any coated optics, special care must be
taken in cleaning the lenses. Moisten the surface of the lens
slightly and wipe dry using a circular motion starting at the center
of the lens. Wipe or brush off any dirt or dust on the outside of the
spotting scope.
caution
Never disassemble your spotting scope. Special tools and
equipment are required for service and irreparable damage can
result from repair attempts by untrained persons. Unauthorized
service may also void the warranty.
CAUTION: DO NOT LOOK AT OR NEAR THE SUN
THROUGH THIS SPOTTING SCOPE, AS SEVERE
DAMAGE TO YOUR EYES MAY RESULT !