StarTech.com RS-232 - Manual (Page 7)

Remote MAC Address:
Enabling this feature allows you to enter the Bluetooth
MAC Address of the remote Bluetooth device
(e.g.000272463b86) to which the Bluetooth to Serial
Adapter will be linking. If it is disabled or MAC address is
left empty, any remote Bluetooth device can pair with the
Bluetooth to Serial Adapter. Once the necessary changes
have been made, please click the Save button, followed by
Yes and OK on the following screens respectively.
Please note: Be sure to click the Save button in each
modification parameter, or settings will be lost.
Configuration: Security
Secure Connection (Default PIN = 1234). Disabling this
function will allow other Bluetooth devices to connect with
this Bluetooth to Serial Adapter without confirming a PIN
code. If it is enabled, then you should enter a PIN code
(length <=12 digits). By default this feature is enabled and
the PIN code is 1234.
PIN stands for Personal Identification Number. Enter the
PIN code, keeping it the same as the remote Bluetooth
device, so the two devices can be paired together.
Once you have made your selection, please click on the
Save button.
Configuration: UART Configure
Change UART parameters, Bluetooth to Serial Adapter
will use them to connect with a RS-232 or RS-422/485
device later.
Baud Rate: 9600 ~ 460800 (Default 115200)
Stop Bit: One/Two (Default One)
Parity Bit: None/Odd/Even (Default None)
Following selection, please press the Save Button.
Please note : Maximum Baud Rate: 460.8 Kbps.
Instruction Manual
4